Time-intensity transformation and internal stress in UV-curable hyperbranched acrylates

The photocuring of three different highly functional acrylates—Di-pentaerythritol penta/hexaacrylate (DPHA) and two hyperbranched molecules (HBP), one with a stiff polyester and one with a more flexible polyether structure—was investigated by means of photorheology, photo differential scanning calorimetry, and beam bending. Special attention was paid to the influence of the composition of DPHA/HBP reactive blends and UV intensity on gelation and vitrification and the resulting dynamics of the internal stress. It was found that adding HBPs to DPHA did not influence gelation significantly, but shifted the onset of vitrification to higher conversions and thus caused lower internal stresses in the material. Increasing UV intensity increased both the conversion at vitrification, thus retarding the build-up of internal stresses, and the ultimate conversion, thus increasing the final stress level. The obtained conversion, gelation, and vitrification data were assembled into time-intensity transformation diagrams, thus providing a useful tool for optimizing photocuring. This paper was presented at Annual European Rheology Conference (AERC) held in Hersonisos, Crete, Greece, April 27–29, 2006.     

各向异性非线性强度条件下的边坡稳定性

解释了土体强度各向异性、非线性的物理本质,结合常规直剪试验、三轴试验结果,在前人工作基础上建立了边坡稳定性分析中强度各向异性、非线性的描述方法,其中特别提出了一个各向异性函数．基于Janbu普遍条分法(GPS),运用SPREADSHEET模板程序,提出了一个能将各向异性、非线性强度准则逐点等效到Mohr-Coulomb直线强度准则处理上的迭代方法,准确方便地获得了非线性强度下的边坡稳定性分析．最后的算例展示了方法的使用过程。     

含夹杂和微裂纹复合材料的损伤演化和分析

利用细观力学的Ｅｓｈｅｌｂｙ和Ｍｏｒｉ－Ｔａｎａｋａ理论，考虑纤维和微裂纹之间的相互作用，研究了定向分布微裂纹的演化规律及其对材料力学性能的影响，分析了纤维体积份数，弹性系数、微裂纹密度，纤维不同取向与基体开裂强度之间的变化关系，并给出了许多有意义的结论。     

ANISOTROPIC EFFECTS OF QUASI-ISOTROPIC COMPOSITES(I)──MODELLING

Experimental observations show that quasi-isotropic materials, such as N-axial fibre-reinforced composites and woven materials, exhibit various degrees of anisotropy in elasticity and strength, and the anisotropy in strength is normally stronger than that in elasticity. In view of some available experimental data and based on the general formulation of the constitutive equations and failure criteria of quasi-isotropic materials established by using the theory of representations for tensor functions, we postulate several applicable models of the constitutive equations and strength for 3-and 4-axial quasi-isotropic materials to reveal the anisotropic effects. In a continued work (Part II), the anisotropic effect in strength of an infinitely large plate with a single elliptical hole or crack is studied, and the proposed stiffness and strength models are verified in terms of micro-mechanical analyses.Project supported by the National Natural Science Foundation of China and the State Education Commission Foundation of China     

树枝状界面相开裂对纤维强度的影响

碳纤维增强铝的复合材料在制造过程中，由于发生化学反应而在界面上形成新相。该相并非均匀附着在纤维表面，而是以纤维为主杆形成树枝状。本文利用剪切滞后理论，同时考虑到界面相亦有承受轴向外载的能力，分析了界面相开裂对纤维强度的影响。结果表明界面相与纤维间界面强度以及该界面脱粘后的摩擦应力的增加都能使纤维在给定外载下破坏的概率减小；另外界面相的厚度、沿纤维方向的弹性模量、剪切模量的增加却使上述概率增加。     

Cavity nucleation, growth and stress field in elastic-plastic medium

A finite element method is used to study the cavity nucleation and growth in an elastic-plastic medium. The critical cohesion strength, _c at IPM (interface between second phase particle and matrix) is employed as the criterion of cavity formation. Three different values of _c are taken to examine their influence on the overall mechanical behaviour and process of cavity formation.     

基于吸力量测确定膨胀土活动带和裂隙深度

采用M itchell公式和裂隙扩展深度方程两种吸力法确定安康地区膨胀土大气影响深度和裂隙开展深度。其一通过对安康地区两处天然边坡开挖观测井,利用张力计进行不同深度处吸力值的现场量测,根据M itchell提出公式计算大气影响深度;其二根据非饱和土抗拉强度公式,建立膨胀土裂隙扩展深度方程,利用基质吸力量测结果求其理论解。结果表明,安康地区膨胀土吸力变化曲线随深度增加变幅减小,呈“波浪式”推移。M itchell公式确定安康地区膨胀土的大气影响深度为3.35m以内,裂隙深度方程确定裂隙开展深度为3.06³.14m。利用M itchell公式计算大气影响深度与膨胀土断裂理论公式确定的裂隙开展深度结果接近。     

天然盐渍土冻融循环时水盐迁移规律及强度变化试验研究

通过对新疆喀什地区12处天然盐渍土室内基本性质试验分析,选取典型天然盐渍土,在开放系统中进行反复冻融循环条件下的试验研究。研究了天然盐渍土在多次冻融循环时的水分和盐分迁移规律及强度变化特征。试验结果表明:经多次冻融循环,低液限粘土试样水分重分布与盐分重分布有很大的一致性,水分和盐分自下而上迁移;试样粘聚力自下而上线形减小,内摩擦角呈s形分布。含砂低液限粘土试样冻融循环过程中,易溶盐均随水分向冷端面迁移,离子剖面呈现中间大两端小的趋势;试样粘聚力呈反s形分布,内摩擦角均呈s形分布。     

高速公路工程中水泥搅拌桩桩身合理设计强度研究

在公路工程的搅拌桩地基设计中,一般假设加固区桩土变形协调,从而采用复合地基理论进行设计。但是目前许多的工程实践表明在路堤荷载作用下,搅拌桩地基桩土之间存在差异沉降,桩身强度不能够完全发挥,为此需要对复合模量的表达式进行改进。本文采用有限元分析了路堤荷载作用下搅拌桩地基的变形响应情况,分析了加固区桩间土变形与桩身模量之间关系,得到了水泥土搅拌桩强度的合理范围。     

Elastoplastic analysis of nonlinearly hardening variable thickness annular disks under external pressure

Based on von Mises’ yield criterion, deformation theory of plasticity and Swift’s hardening law, elasto-plastic deformation of variable thickness annular disks subjected to external pressure is studied. A nonlinear shooting method using Newton’s iterations with numerically approximated tangent is designed for the solution of the problem. Considering a thickness profile in the form of a general parabolic function, the condition of occurrence of plastic deformation at the inner and outer edges of the annular disk is investigated. A critical disk profile is determined and the corresponding elastic–plastic stresses as well as the residual stress distribution upon removal of the applied pressure are computed and discussed.